Disclaimer

Please, proceed carefully following the tips published in this blog, specially when Main Power is involved. I'm not responsible for any damages caused by what is written in this blog.
Thank you

Friday 16 January 2015

Arduino Uno Rev 3 Starter Kit




After many research over the internet, we decided to buy on ebay the Arduino Uno Starter Kit.

We got it in a few days.


It contains:

  • 1 Arduino UNO R3 Board, made in Italy
  • 1 USB Cable 50cm
  • 1 Breadboard 830 points
  • 1 Display LCD 16X2 backlighted, Hitachi HD44780 driver
  • 2 Linear Pots 10Kohm
  • 2 Knobs
  • 1 9V Battery connector
  • 65 Jumpers
  • 10 Buttons
  • 1 Buzzer
  • 1 relay 5V 10A 250VA
  • 1 Temp Sensor LM35
  • 2 Transistor BC547
  • 1 Light Sensor
  • 10 Red LED
  • 10 Yellow LED
  • 10 Blue LED
  • 10 Green LED
  • 10 White LED
  • 1 RGB LED
  • 2 capacitors 4,7uF 100V
  • 5 Diode 1N4007
  • 10 Resistor 1Kohm
  • 10 Resistor 10Kohm
  • 10 Resistor 4,7Kohm
  • 20 Resistor 470ohm

I think we have enough things to begin experiments...

In the same shipping we received also:

RF 433 Mhz Transmitter and receiver modules



Ethernet shield based on W5100 chip with an sd card reader on board


an MQ-4 gas sensor


some RGB LED


Ok, don't waste our time...we are ready to begin some real experiments...

No comments:

Post a Comment