Disclaimer

Please, proceed carefully following the tips published in this blog, specially when Main Power is involved. I'm not responsible for any damages caused by what is written in this blog.
Thank you

Sunday, 18 January 2015

First experiment: a simple gas detector




Let's begin assembling some stuff from starter kit...as first example we will try to build a simple "gas detector" using MQ-4 sensor.

Here is the datasheet


The sensor has 3 pins:

- Vcc: 5V supply voltage, Arduino friendly;
- GND: ground connection;
- AD: analog output; provides a value congruent with the gas concentration in the air;
- D0: triggered digital output; provides an HIGH signal when the gas concentration exceeds a limit; you can set this limit through the trigger;


We will use only the analog output, which will be linked to an Arduino's analog input pin.

The sensor needs a pre-heating time.

In our prototype, just for example, we will use also:

- a temp sensor: LM 35
- an LCD display 16X2 backlighted with Hitachi HD44780 driver
- a Buzzer
- a led
- a pot

On the display we will show datas provided by the sensors; led and buzzer will be used to signal warnings and alerts and the pot controls the LCD display dimmer.

Here is the demonstration video: